Test with a multimeter
Speaker
Now: Coil resistance
Pin 1: Plus (+) (+) Pin 2: Minus (−) (−)
Red probe Not connectedBlack probe Not connected
LED litHold the probe and drag it to the tip of a leg. Tapping works too: first pick the probe, then the leg.
· beep
Set the range to Ω (resistance).
Measurement taken while pressed is saved. You can go to the next step.
Measure step by step
A speaker’s coil shows a few ohms at DC, a bit less than the impedance printed on it. This test checks only the coil, not the sound.
- 1Coil resistance